When you insert a cable into the switch’s RJ-45 port, the switch automatically performs
the following actions:
•
Senses whether the cable is a straight-through or crossover cable.
•
Determines whether the link to the attached device requires a normal connection
(such as when you are connecting the port to a computer) or an uplink connection
(such as when you are connecting the port to a router, switch, or hub).
•
Automatically configures the RJ-45 port to enable communications with the attached
device. The Auto Uplink technology compensates for setting uplink connections
while eliminating concern about whether to use crossover or straight-through cables
when you attach devices.
Fiber transceiver modules and cables for SFP+ and SFP28
ports
To enable high-speed fiber and Gigabit Ethernet, short- and long-distance connections
on the switch, SFP+ and SFP28 fiber ports can accommodate standard 1G SFP and 10G
SFP+ transceiver modules and direct attach cables (DACs), all of which are sold
separately. The switch also supports third-party, high-speed fiber transceiver modules
and DACs.
The switch supports the following NETGEAR SFP and SFP+ transceiver modules and
cables:
•
Short-reach fiber transceiver modules:
- AGM731F: SFP transceiver 1000BASE-SX, SFP multimode LC GBIC
- AXM761: SFP+ transceiver 10GBASE-SR, SFP+ multimode LC GBIC
•
Long-reach fiber transceiver modules:
- AGM732F: SFP transceiver 1000BASE-LX, SFP single mode LC GBIC
- AXM762: SFP+ transceiver 10GBASE-LR, SFP+ single mode LC GBIC
- AXM763: SFP+ transceiver 10GBASE-LRM, SFP+ multimode LC GBIC
- AXM764: SFP+ transceiver 10GBASE-LR Lite, SFP+ single mode LC GBIC
•
Gigabit transceiver modules:
- AGM734: SFP transceiver 1000BASE-T, SFP copper RJ-45 GBIC
- AXM765: SFP+ transceiver 10GBASE-T, SFP+ copper RJ-45 GBIC
Hardware Installation Guide37Hardware Overview
Fully Managed Switches M4350 Series
To Next Page
Loading...
Need help?
General