NETGEAR M4350 Series User Manual

(Continued)
ItemNumber
A bag with the following screws for rack-mounting:
•
Eight small screws to attach the brackets to the switch (four small screws for each side).
•
Four medium-sized screws to attach the brackets to the rack (two screws for each side).
•
Four large screws to attach the brackets to the rack (two screws for each side).
Note: Depending on the type of rack, use either the medium-sized screws or the large screws
to attach the brackets to the rack.
4
Rubber feet for desktop or table installation5
Installation guide6
Two medium-sized brackets with a depth of 4.75 inches (12 cm). Use both of these brackets to
mount the switch set back in a rack.
7
Two medium-sized brackets with a depth of 2.75 inches (7 cm). Use both of these brackets to
mount the switch flush in a rack.
8
5.
If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
Unpack a half-width model
This section applies to the following half-width models:
•
M4350-8X8F
•
M4350-12X12F
The following figure shows the package contents for model M4350-12X12F, but the
contents for all half-width models are very similar, other than the switch model.
Hardware Installation Guide51Installation
Fully Managed Switches M4350 Series

NETGEAR M4350 Series Specifications

General

Brand	NETGEAR
Model	M4350 Series
Category	Switch
Language	English