NETGEAR M4350 Series User Manual

6.
Align the mounting holes in the brackets (on the left of the left switch and on the
right of the right switch) with the holes in the rack, and depending on the rack, insert
the medium-sized or large screws through each bracket and into the rack.
•
Flush-mounting example
•
Set-back mounting example
7. Tighten the screws with a No. 2 Phillips screwdriver to secure the brackets to the
rack.
Detach two connected half-width switches
After you detach and remove two connected half-width switches from a rack, follow the
steps in this procedure to detach the switches from each other.
Hardware Installation Guide60Installation
Fully Managed Switches M4350 Series

NETGEAR M4350 Series Specifications

General

Brand	NETGEAR
Model	M4350 Series
Category	Switch
Language	English