To Next Page

To Previous Page

14 – English

08. If the dangerous situations caused by the movement of the door have been safeguarded by limiting the force impact, the user must

measure the impact force according to the EN 12445 standard.

If the adjustment of the 'Speed' and control of the 'Motor Force' are used to assist the system for the reduction of the impact force, try

to nd the adjustment that gives the best results.

6.2 - Commissioning

Commissioning can only take place once all the testing phases have terminated successfully (Paragraph 6.1).

Partial or makeshift commissioning is forbidden.

01. Draw up and store (for at least 10 years) the automation’s technical le, which must include at least the following: the assembly drawing

of the automation, a wiring diagram, risk analysis and relative solutions adopted, the manufacturer’s declaration of conformity for all

the devices used (for SPIN use the enclosed EC Declaration of Conformity), and a copy of the automation’s instructions for use and

maintenance schedule.

02. Permanently attach the manual release (manual manoeuvre) label close to the manoeuvring assembly

03. Permanently attach a label or sign on the door containing the

adjacent picture (min height 60 mm):

04. Afx a label to the door containing at least the following data: type of automation, name and address of manufacturer (person responsible

for commissioning), serial number, year of manufacture and the CE mark.

05. Draw up the declaration of conformity of the automation and hand it to the owner of the automation.

06. Deliver the user manual (pull-out insert) to the owner of the automation.

07. Draw up the maintenance schedule and hand it to the owner of the automation.

08. The force adjustment is an important safety factor and must be done with the utmost care by qualied technicians

Important! - Adjustments set to force loads higher than those allowed may cause injury to persons and animals or damage to things.

Adjust the force to the minimum available value to allow rapid and reliable detection of any obstacles.

09. Before commissioning the door, inform the owner properly and in writing about the attendant residual risks.

Nice Spin10KCE User Manual

Other manuals for Nice Spin10KCE