Nice Spin10KCE User Manual

English – 29
This user guide should be stored and handed to all users of the automation.
WARNINGS
• Keep at a safe distance from the moving door until it is completely open or closed; do not transit through the door until it is completely
open and has come to a standstill.
• Do not allow children to play near the door or with the controls.
• Keep the transmitters away from children.
• Suspend the use of the automation immediately as soon as you notice any abnormal operation (noises or jolting movements); failure
to follow this warning may cause serious danger and accidents.
• Do not touch moving parts.
• Regular checks must be carried out by qualied personnel according to the maintenance plan.
• Maintenance or repairs must only be carried out by qualied technical personnel.
• Send a command with the safety devices disabled:
In the event of safety devices malfunctioning or out of service, the door may still be moved.
01. Command the door control with the transmitter. The door will open normally if the safety devices give the enable signals, otherwise within 3 seconds
the control must be activated again and held.
02. After approximately 2 seconds the door will start moving in the “man present” mode, i.e. so long as the control is held the door will keep moving;
as soon as the control is released the door will stop.
If the safety devices are out of order, arrange to repair the automation as soon as possible.
Releasing and locking the gearmotor (manual operation)
The gearmotor is equipped with a mechanical system that allows for manually opening and closing of the door.
Manual operation must be performed in the case of a power outage or in the event of anomalies affecting the system.
In the event of a gearmotor fault, it is still possible to try release the motor to check whether the fault lies in the unlocking mechanism.
CLAK
Maintenance operations admissable to the user
The operations that the user must carry out periodically are listed below:
• Cleaning of the surfaces of the devices: use a slightly damp (not wet) cloth. Do not use substances containing alcohol, benzene, thin-
ners or other ammable substances; the use of these substances may damage the devices and cause res or electric shocks.
• Removal of leaves and stones: disconnect the power supply to the automation before proceeding, to prevent anyone from moving the
door. If a buffer battery is tted, disconnect it.
USER GUIDE (to be handed to the end user)

Nice Spin10KCE Specifications

General

Brand	Nice
Model	Spin10KCE
Category	Garage Door Opener
Language	English