Installation
3-22
Part 1073401_07
E 2021 Nordson Corporation
Installing Optional Equipment
Each item of optional equipment is shipped with instructions for installing and
operating the equipment. Refer to Section 7, Parts, for equipment part
numbers.
Connecting a Applicator Driver, Pattern
Controller, or Timer
If applicable, complete the melter installation by connecting the applicators to
the desired applicator driver, pattern control, or timer. Refer to the product
manual provided with the device for information about installing and
operating the equipment.
Flushing the Melter
WARNING! Risk of Burns! New melters contain a small quantity of
low‐viscosity test fluid. Test fluid may splatter when discharged under high
pressure. Before flushing the melter, ensure that the pressure control valve is
set to low pressure.
Before using the melter for production, it should be flushed to remove any
residue left over from factory‐testing. Flushing the melter is accomplished by
processing a minimum of one tank volume of hot melt through the melter,
hoses, and applicators.
Refer to Section 4, Operation, for information about filling the tank and
operating the melter.
To Next Page
Loading...
Need help?
General
