B930n User’s Guide> 32
L
OADING
MPF (T
RAY
5)
The MPF can be used for both manual and automatic feeds. There is
an indicator label on the tray that shows the positioning of each side
of paper. This label addresses long-edge and short-edge orientation.
For custom size paper loaded in the MPF, you must change the paper
type and size on the Operator Panel to match the paper that you
loaded.
Side guides must be set accurately against the sides of paper. The
printer uses the placement of these guides to calculate and verify
the correct paper size.
1. Lower the MPF tray.
2. Adjust the paper guides to the size of the paper.
To Next Page
Loading...
Need help?
General
