B930n User’s Guide> 39
B
INDING
P
REFERENCES
You can select how the printer will orient the page layout when
duplexing. Depending on your page orientation, duplexing on the
long-edge or short-edge of the paper produces different results. The
diagram below illustrates these results.
P
RINTING
ON
S
PECIAL
M
EDIA
The printer can accommodate a variety of special media. Each media
type requires some special handling. Read the sections below for
each special media type, prior to inserting the media into the tray.
The most convenient way to enable this feature is by using your
Printer Properties. You may also enable this feature at the Operator
Panel or by using the EWS.
To select the special media types through your Printer Properties:
1. Select the desired Media Type from the Media Type pulldown
in the Setup Tab of your Printer Properties.
2. Click OK.
S
ETTING
M
EDIA
T
YPES
Settings on the Operator Panel and in your Printer Properties are
required for media loaded in all trays trays. Media type settings must
match those of the actual paper loaded in the trays. Otherwise,
image quality cannot be processed accurately. Toner may not fuse
properly on the media, resulting in dirty and poor quality printouts.
T
RANSPARENCIES
Transparencies can be printed from any tray. They should only be
printed on one side.
Before printing transparencies:
Portrait
Long-edge
Portrait
Short-edge
Landscape
Short-edge
Landscape
Long-edge
To Next Page
Loading...
Need help?
General
