B930n User’s Guide> 47
I
NPUT
T
RAY
L
INKING
When an input tray runs out of paper, auto tray changing enables
the printer to switch to another available tray that contains the same
size and paper type. You can select auto tray changing via the
operator panel, Printer Properties, or web interface.
The most convenient way to enable this feature is by using your
Printer Properties. You may also enable this feature at the Operator
Panel or by using the EWS.
To select auto tray changing through your Printer Properties:
1. Select the Paper Feed button in the Setup tab within your
Printer Properties.
The Paper Feed Options window appears.
2. Select Auto Tray Change.
3. Click OK.
4. Click OK.
O
UTPUT
B
IN
LINKING
When an output bin reaches capacity, the tray full sensors are
activated. You can select out put bin linking to have remaining pages
sent to an open bin. By default this option is turned on. It is located
in the Operator Panel’s Print Menu.
M
ANUAL
F
EED
Tray MPF can be used for manual feed. You must also set your
Printer Properties for manual feed. Tray 1 MPF normally operates in
multi-purpose mode, where multiple sheets can be loaded and
printed continuously. In manual mode, you are prompted to press
the Start key for each sheet.
The most convenient way to enable this feature is by using your
Printer Properties. You may also enable this feature at the Operator
Panel or by using the EWS.
To select manual feed through your Printer Properties:
1. Select the Paper Feed button in the Setup tab within your
Printer Properties.
The Paper Feed Options window appears.
To Next Page
Loading...
Need help?
General
