B930n User’s Guide> 46
7. Click OK.
8. Click OK.
9. Click OK.
T
RAY
S
ETTINGS
You can configure a variety of settings for your input trays and
output bins. The default settings for your source input tray and
output bin are configured through the Operator Panel’s Paper menu,
Default Source and Output Tray selections.
S
OURCE
You can select the input tray from which paper is used to print the
job.
The most convenient way to enable this feature is by using your
Printer Properties. You may also enable this feature at the Operator
Panel or by using the EWS.
To select the paper source through your Printer Properties:
1. Select the desired Source from the Source pulldown in the
Setup Tab of your Printer Properties.
NOTE
> If there are no paper trays that match the automatic tray
selection, an error message prompting for replenishment
of paper will be displayed.
2. Click OK.
O
UTPUT
D
ESTINATION
You can choose the output bin where your print job will be placed.
The most convenient way to enable this feature is by using your
Printer Properties. You may also enable this feature at the Operator
Panel or by using the EWS.
To select the paper destination through your Printer Properties:
1. Select the desired Destination from the Destination pulldown
in the Setup Tab of your Printer Properties.
2. Click OK.
To Next Page
Loading...
Need help?
General
