Oki N36800B User Manual

Basic operations
- 75 -
Envelope
 The paper may warp or wrinkle after printing.
 The toner may stick thinly to the whole paper or the printing may be light.
 The toner may be easily removed.
 The printing quality may decline in an area of about 5 mm around the sealing part (of different weights) of
the envelope.
 The warps on an envelope may cause poor paper feeding. Use the envelope after correcting warps or
bulges.
 If the glued part at the rear edge of the envelope is bent, it may cause poor paper feeding. Correct the
bending before use.
 Duplex printing is not available.
 Always perform trial printing and check that there are no problems.
Label
 The toner may stick thinly to the whole paper or the printing may be light.
 The toner may be easily removed.
 The warps on the front edge of a label may cause poor paper feeding. Use labels after correcting warps
or bulges.
 Duplex printing is not available.
 Always perform trial printing and check that there are no problems.
Long paper
 For thick paper, the toner may stick thinly to the whole paper or the printing may be light.
 If the paper grain direction does not match the paper feeding direction, paper jams may occur.
 Do not use paper that has been printed once with a thermal transfer printer, inkjet printer, etc.
 The paper wrapper shows the orientation of the surface. Load paper properly so that the face side is the
printing side.
 The paper is wrapped in moisture-proof paper to prevent moisture. Please use the paper as early as
possible after opening its package.
 If the paper has a GSM weight other than 128 g/m
2
, the print quality may deteriorate. Always perform trial
printing and check that there are no problems.
 Be sure to set the paper size to portrait length. The portrait length cannot be set to a value shorter than
the landscape length.
 Some applications may not be available.
 Even when using under the recommended conditions, the long paper with a length exceeding 356 mm
may not be able to guarantee the print quality.
Irregular-sized paper (custom size)
 Skewing, curling, warping, folded corners (the edge is folded) and paper jams caused by these factors
may occur. Check the print result of the paper to be used in advance.
 Register the paper in portrait orientation and load it in portrait orientation in the tray.
 If the length exceeds 356 mm, use the rear output tray.
 Some applications may not be available.
 The quality of printing on the paper with a length exceeding 356 mm will be not guaranteed.
 If the paper is too long and protrudes from the paper supporter of the MP tray, support the paper with
your hand.

Oki N36800B Specifications

General

Brand	Oki
Model	N36800B
Category	Printer
Language	English