Omron CP1E - INTRODUCTION User Manual

5-1 Going Online
5
5
SYSMAC CP1L/CP1E Introduction Manual 87
5
Transferring and Debugging Programs
2. Click [Yes].
The operating mode will be changed.
o
The operating mode will be displayed on the title bar and on the project tree.
■CP1L Operating Mode
CP1L has 3 operating modes: PROGRAM, MONITOR, and RUN. Change the
operating mode to reflect the operation to be performed. The operation mode
affects the whole user program, and is common to all tasks.
• PROGRAM mode:
In this state, the program is stopped. This mode is used to prepare for program
execution by performing initial settings such as PLC setup, transferring the
program, checking the program, and force-setting/force-resetting.
• MONITOR mode:
In this state, the program is executed. You can perform online editing, force-set/
force-reset, and change I/O memory values. This mode is also used for making
adjustments during test runs.
• RUN mode:
In this state, the program is executed. Use this mode for production runs.

Omron CP1E - INTRODUCTION Specifications

General

Series	CP1E
Manufacturer	Omron
Input Voltage	100 to 240 VAC or 24 VDC (depending on model)
I/O Points	10 to 60 points
Number of Inputs	6 to 36 points
Number of Outputs	4 to 24 points
Communication Ports	USB, RS-232C
Programming Language	Ladder Diagram (LD)
Power Supply	100-240V AC or 24V DC
Storage Temperature	-25°C to 65°C
Vibration Resistance	10 to 57 Hz, 0.075mm amplitude
Shock Resistance	147 m/s², 3 times each in X, Y, Z directions
Weight	Varies by model
Type	Programmable Logic Controller (PLC)

Summary

Introduction and Preliminary Information

Precautions and Safety Guidelines

Details essential precautions, intended audience, safety measures, and application guidelines for safe operation.

Section 1: CP1L/CP1E Overview

CP1L/CP1E Models

Section 2: Designing Systems

Section 3: Mounting and Wiring

Installation Notes and Considerations

Unit Mounting and Wiring Procedures

Power Testing and Verification

Section 4: Creating Programs

Programming Preparation and Setup

Ladder Program Creation Process

Explains how to construct ladder programs for the shutter control system example.

Using CX-Programmer Software

Covers starting and navigating the CX-Programmer software interface for program development.

Inputting and Editing Program Elements

Step-by-step guide to entering ladder logic elements and modifying comments and rungs.

Section 5: Transferring and Debugging Programs

Establishing Online Connection

Describes establishing a connection between the computer and CP1L for program transfer and monitoring.

CP1L Clock and Operating Mode Settings

Program Transfer and Execution

Step-by-step process for transferring programs from CX-Programmer to CP1L and executing them.

Online Adjusting and Debugging Techniques

Covers monitoring, force-setting, searching, and online editing for efficient debugging.