Omron E5AN User Manual

102
Using Event Inputs Section 4-5
The following table shows the relationship between the Multi-SP Uses param-
eter set value and the selected set point.
Note The set point can also be switched using communications.
4-5-3 Settings
Switching between Set Points 0, 1, 2, and 3
Operating Procedure The following example sets the Number of Multi-SP Uses parameter to 2.
Set points 0, 1, 2 and 3 will be set according to the ON/OFF states of event
inputs 1 and 2.
4-5-4 Operation Commands Other than Multi-SP
The following table shows the functions assigned when an Event Input
Assignment (1 or 2) is displayed.
Multi-SP Selected set point
0 Set point 0
1 Set point 1
2 Set point 2
3 Set point 3
Operation Level
1. Press the O Key for at least three seconds to move from the operation
level to the initial setting level.
Number of Multi-SP Uses Setting
2. Select the Number of Multi-SP Uses parameter by pressing the M Key.
3. Use the U Key to set the parameter to 2.
C
25
100
PV/SP
ev-m
1
Number of
Multi-SP Uses
ev-m
2
E5CN
EV1
EV2
EV1
EV2
+
−
+
EV1
EV2
EV1
EV2
+
−
+
E5AN/EN E5GN
11
12
13
11
12
13
+
−
+
EV1
EV2
EV1
EV2
7
8
9
Setting Function
none None
stop RUN/STOP
manu Auto/Manual
prst Program Start (See note 1.)
drs Invert Direct/Reverse Operation
at-2 100% AT Execute/Cancel
at-1 40% AT Execute/Cancel (See note 2.)
wtpt Setting Change Enable/Disable
lat Alarm Latch Cancel

Omron E5AN Specifications

General

Brand	Omron
Model	E5AN
Category	Temperature Controller
Language	English