To Next Page

To Previous Page

108

Moving to the Advanced Function Setting Level Section 4-8

Alarms during SP

Ramp Operation

The operation of alarms during SP ramp operation depends on whether

alarms are set to be based on the ramp set point or the target set point (refer

to the following diagrams). The set point to be used is set in the Alarm SP

Selection parameter. (Refer to page 244.)

4-8 Moving to the Advanced Function Setting Level

To move to the advanced function setting level, you must first cancel the pro-

tection applied by the Initial Setting/Communications Protect parameter.

In the default setting, the advanced function setting level is protected and you

cannot move to this setting level.

1,2,3... 1. Press the O and M Keys simultaneously for at least three seconds in op-

eration level.

Note The key pressing time can be changed in the Move to Protect Level

Time parameter (advanced function setting level).

Alarm SP Selection = Ramp SP (Alarm Type: 1 (Upper/Lower Limits))

Alarm SP Selection = Target SP (Alarm Type: 1 (Upper/Lower Limits))

Temperature

Time

Alarm output ON

Protect Level

2. The Controller moves to the protect level, and the Operation/Adjustment

Protect parameter is displayed.

3. Press the M Key once to move to the Initial Setting/Communications Pro-

tect parameter.

4. Set the set value to 0.

oapt

Operation/Adjust-

ment Protect

icpt

Initial Setting/

Communica-

tions Protect

Omron E5AN User Manual

Other manuals for Omron E5AN