Omron E5GC User Manual

5 Advanced Operations
5 - 12
E5@C Digital Temperature Controllers User’s Manual (H174)
Note: The set point can also be switched using communications.
The following table shows the functions that can be assigned when an Event Input Assignment 1 or 6
parameter is displayed.
*1 PRST (Program Start) can be set even when the Program Pattern parameter is set to OFF, but the function
will be disabled.
*2 This function can be set only for a Digital Controller that supports a remote SP input.
*3 This function can be set for heating/cooling control or for floating control for Position-proportional Models, but
the setting will be disabled.
*4 This function can be set only for a Digital Controller that supports communications. Also, when a work bit is
selected as the event input data, Communications Write Enable/Disable cannot be assigned.
*5 If the same function is assigned to PF Key, it will be disabled for the PF Key and only the event input can be
used to execute the function.
Turn event inputs ON and OFF while the power is being supplied. Event input ON/OFF changes are
detected for inputs of 50 ms or longer.
The functions are described in detail below.
 Executing Run/Stop Control
When the Event Input Assignment parameter is set to STOP (RUN/STOP), control is started when
event input turns OFF. Control is stopped when the input turns ON. Alarm outputs, however, will be
according to the process value.
The STOP indicator will light while control is stopped.
Multi-SP Selected set point
0 SP 0
1 SP 1
2 SP 2
3 SP 3
4 SP 4
5 SP 5
6 SP 6
7 SP 7
5-4-3 Operation Commands Other than Multi-SP
Setting Function
none None
stop
RUN/STOP
*5
manu
Auto/Manual
*5
prst
Program Start
*1
drs Invert Direct/Reverse Operation
rsp
SP mode switch
*2
at-2
100% AT Execute/Cancel
*5
at-1
40% AT Execute/Cancel
*3*5
wtpt Setting Change Enable/Disable
cmwt
Communications Write Enable/Disable
*4
lat
Alarm Latch Cancel
*5
msp0 Multi-SP No. switching bit 0
msp1 Multi-SP No. switching bit 1
msp2 Multi-SP No. switching bit 2

Omron E5GC Specifications

General

Brand	Omron
Model	E5GC
Category	Temperature Controller
Language	English