5 - 39
5 Advanced Operations
E5@C Digital Temperature Controllers User’s Manual (H174)
5-13 Using the Transfer Output for the Process Value, Set Point, or other Data
5
5-13-2 Simple Transfer Output Function
With the E5CC-U,* E5DC,* E5DC-B, or E5GC, if the control output is a linear current output, the control
output can be used as a simple transfer output.
* The E5CC-U must be manufactured in May 2014 or later (version 2.2 or higher) and the E5DC must be
manufactured in July 2014 or later (version 2.2 or higher).
Precision and User Calibration
* However, the precision between 0 and 4 mA for a 0 to 20-mA output is ±1% FS.
Control Output 1 Signal (Initial Setting Level)
You can use the Control Output 1 Signal parameter to specify whether to output 4 to 20 mA or 0 to
20 mA from the simple transfer output.
Terminal Arrangement
Control Output 1 Assignment (Advanced Function Setting Level)
To use the simple transfer output, specify any of the following five types of data to output with the
Control Output 1 Assignment parameter.
* This function can be set for standard control, but the setting will be disabled.
5-13-2 Simple Transfer Output Function
Precision User calibration
±0.3% FS* None
Setting range Default
4-20: 4 to 20 mA
4-20
0-20: 0 to 20 mA
Simple transfer output type
(Control Output 1
Assignment)
Display Setting range
Simple transfer SP t-sp SP lower limit to SP upper limit
Simple transfer ramp SP tspm SP lower limit to SP upper limit
Simple transfer PV
t-pV Input setting range lower limit to input setting range upper limit,
or Scaling lower limit to scaling upper limit
Simple transfer MV (heating) t-mV −5.0 to 105.0 (heating/cooling control: 0.0 to 105.0)
Simple transfer MV (cooling)* tcmV 0.0 to 105.0
-
Linear current output
Linear current output
-
Control
output 1
+
-
+
+
E5DC
E5GC
E5CC-U
+
Control output 1
D
C
-
Linear current output
Linear current
output
E
F
D
E
F
E5DC-B
D
C
Control output 1
To Next Page
Loading...
Need help?
General
