A-35
Appendices
NJ/NX-series CPU Unit Built-in EtherCAT Port User’s Manual (W505)
A-5 Version Information
A
A-5 Version Information
This appendix describes the changes in and additions to functional specifications that were made for
changes in the unit version of the CPU Units.
Changes in and Additions to Functional Specifications
The following table gives the unit version of the CPU Units and the Sysmac Studio version for each
addition or change to the functional specifications.
*1 This function was added to the NJ301- and NJ101- CPU Units. The function is supported with
all other CPU Unit models regardless of their versions.
Adding the EtherCAT Slaves That You Can Use
If you use a newer unit version of the CPU Unit, you can increase the OMRON EtherCAT Slaves
that you can use. Refer to 1-2-1 System Configuration for details.
For information on the most recent lineup of the OMRON EtherCAT slaves, NX-series EtherCAT
Communications Coupler Units and NX Units, refer to catalogs or OMRON websites, or ask your
OMRON representative.
Function Addition/change Reference Unit version
Sysmac Studio
version
Backup and restore
operations
Addition page 9-29 and 9-30 1.03 1.04
Enabling/disabling Addition page 5-18 and 5-21 1.04 1.05
Packet monitoring
*1
Addition page 6-27 and A-8 1.10 1.12
Diagnosis/statistics
log
Addition page 9-18 1.11 −
To Next Page
Loading...
Need help?
General
