Omron NX102 series User Manual

2 Part Names and Slave Settings
2-16
NJ/NX-series CPU Unit Built-in EtherCAT Port User’s Manual (W505)
The following table shows the relationship between Sysmac device features and EtherCAT masters.
*1 Error notification is provided with emergency messages.
*2 EtherCAT slaves for which data can be backed up have specific precautions. Refer to the NJ/NX-series CPU
Unit Software User's Manual (Cat. No. W501) for details on the precautions.
*3 You cannot specify data to back up and restore.
*4 The ability to back up and restore data depends on the ability of the EtherCAT master from another manufac-
turer.
*5 The ability to store node addresses depends on the ability of the EtherCAT master from another manufacturer.
*6 The ability to verify serial numbers depends on the ability of the EtherCAT master from another manufacturer.
*1 Error notification is provided with emergency messages.
*2 EtherCAT slaves for which data can be backed up have specific precautions. Refer to the NJ/NX-series CPU
Unit Software User's Manual (Cat. No. W501) for details on the precautions.
*3 You cannot specify the data that is backed up and restored.
*4 The ability to back up and restore data depends on the ability of the EtherCAT master from another manufac-
turer.
*5 Setting is possible on the node address switches. Node addresses set with the software cannot be stored in
the slave.
*6 The ability to store node addresses depends on the ability of the EtherCAT master from another manufacturer.
2-3-4 Sysmac Device Features and EtherCAT Masters
OMRON Sysmac Device Slaves
Sysmac device feature
OMRON EtherCAT master
EtherCAT master from
another manufacturer
NJ/NX-series CPU Unit
NX701-
NX102-
NX1P2-
NJ501-
NJ301-
NJ101-
CJ1W-NC8 CJ-series
Position Control Unit
Troubleshooting Supported.
Not supported.
*1
Not supported.
*1
Backing up and restor-
ing parameters
Supported.
*2
Partially supported.
*3
Partially supported.
*4
Saving node address
settings
Supported. Supported.
Partially supported.
*5
Verifying the EtherCAT
network configuration
Supported. Not supported.
Partially supported.
*6
OMRON Slaves That Do Not Support Sysmac Devices
Sysmac device feature
OMRON EtherCAT master
EtherCAT master from
another manufacturer
NJ/NX-series CPU Unit
NX701-
NX102-
NX1P2-
NJ501-
NJ301-
NJ101-
CJ1W-NC8 CJ-series
Position Control Unit
Troubleshooting
Not supported.
*1
Not supported.
*1
Not supported.
*1
Backing up and restor-
ing parameters
Supported.
*2
Partially supported.
*3
Partially supported.
*4
Saving node address
settings
Partially supported.
*5
Partially supported.
*5
Partially supported.
*6
Verifying the EtherCAT
network configuration
Not supported. Not supported.
Partially supported.
*7

Omron NX102 series Specifications

General

Brand	Omron
Model	NX102 series
Category	Controller
Language	English