Omron NX102 series User Manual

5 Setting Up EtherCAT Communications with the Sysmac Studio
5-2
NJ/NX-series CPU Unit Built-in EtherCAT Port User’s Manual (W505)
5-1 Overview of Network Configuration
Information
To execute EtherCAT communications, you must create the following three types of data with the Sys-
mac Studio and download the data to the CPU Unit. When this data is set, the network configuration
information is automatically created.
When you download the network configuration information to the CPU Unit, the EtherCAT master initial-
izes slaves and performs process data communications based on the network configuration informa-
tion. This section describes the procedures to set the network configuration information and how to
check EtherCAT communications.
Network Configuration Information
Network configuration infor-
mation
1. EtherCAT network configuration
2. Process data information
This is allocation information for PDO data in the slaves. It is also called PDO
mapping data.
3. EtherCAT master and slave parameter settings
(Examples: Fail-soft Operation Setting and Wait Time for Slave Startup)
Wait Time for Slave
Startup
EtherCAT
The network configu-
ration information is
downloaded.
PDO data for
Servo Drive slaves
PDO data for
EtherCAT slaves
Process Data Information
Slaves
Master
EtherCAT Master
Parameter Settings
EtherCAT network configuration
Network Configuration Information
EtherCAT master
Sysmac Studio
NJ/NX-series CPU Unit
Etc.
Fail-soft Operation
Setting

Omron NX102 series Specifications

General

Brand	Omron
Model	NX102 series
Category	Controller
Language	English