Oracle StorageTek T10000 Reference Manual

Implementation Requirements
August 2016 Commands 39
Implementation Requirements
The initiator sends commands to the target using Command Descriptor Blocks
(CDBs). The CDBs contain a format that includes:
• Operation code
• Command parameters
• Control byte
For some commands, a list of parameters accompanies the request during subsequent
FCP_DATA Information Units.
For all commands, if there is an invalid parameter in the Command Descriptor Block,
then the device terminates the command without altering the medium or executing
the command.
Notes:
• The CDB Field in Byte 1, Bits 7-5, which was the LUN Field is now
reserved. The drive will ignore this field.
• RSVD indicates that “bit” is reserved.

Oracle StorageTek T10000 Specifications

General

Form Factor	5.25-inch half-height
Interface	SCSI Ultra320 LVD
Data Cartridge	T10000
MTBF	250, 000 hours
Type	Tape Drive
Data Transfer Rate (native)	240 MB/s
Native Data Rate	240 MB/s
Transfer Rate (compressed)	480 MB/s