Mode Select Command
August 2016 Commands 95
Read/Write Error Recovery Page
TABLE 3-52 Mode Select Read/Write Error Page
Byte
Bit
76543210
0 PS SFP (0) Page Code (01h)
1 Page Length (0Ah)
2 Reserved TB RSVD ERR PER DTE DCR
3 Read Retry Count
4
thru
7
(MSB)
Reserved
(LSB)
8 Write Retry Count
9
thru
11
(MSB)
Reserved
(LSB)
Parameter Value
PS: Parameters Savable 0 = Not supported
SPF: SubPage Format 0 = Mode page format
TB: Transfer Block 0 = Unrecoverable data block not transferred
ERR: Enable Early Recovery 0 = Normal error recovery
PER: Post Error 0 = Normal mode
DTE: Disable Transfer on Error 0 = Normal mode
DCR: Disable Correction 0 = Always use error correction codes
Read Retry Count Extent of error recovery during read operations
Count ignored, always maximum recovery
WriteRetry Count Extent of error recovery during the write operations
0h 5 minutes (same as default)
1h – 13h 10 seconds
14h – 3Bh 1 minute
3Ch – 63h 3 minutes
64h – 77h 5 minutes
78h – C7h 6 minutes
C8h – FFh 10 minutes
64h Default value (5 minutes)
To Next Page
Loading...
Need help?
General