Inquiry Command
50 T10000: Interface Reference Manual August 2016
Parameter Value
Peripheral Qualifier 000b = Peripheral device is connected to this logical unit
011b = Not capable of supporting a device on this logical unit
Peripheral Device Type 01h = Device is a sequential access device (tape drive)
1Fh = Device does not exist or is offline
RMB: Removable Medium Bit 1 = Medium is removable
ECMA Version
European Computer Manufacturers
Association
05h = Complies with ANSI INCITS 408-2005 (SPC-3)
AERC: Asynchronous Event
Reporting Capability
0 = Not supported
NormACA: Normal Auto Contingent
Allegiance
0 = Not supported
HiSup: Hierarchical Support 0 = Not supported
Response Data Format 02 = Inquiry data is in ANSI SPC–2 format
Additional Length 45h = 69 additional bytes of data follows
SCCS: SCSI Controller Command
Support
0 = Not supported
ACC: Access Controls Coordinator 0 = Not supported
TPGS: Target Port Group Support 01b = Supports only implicit asymmetric logical unit access
3PC: Third-Party Copy 0 = Not supported
Protect 0 = The logical unit does not support protection information.
1 = The logical unit supports protection information.
BQue: Basic Queuing 0 = Not Supported
EncServ: Enclosure Services 0 = Not supported
VS: Vendor Specific 0 = Not supported
MultiP: Multi-Port 1 = Supports two ports
MChngr: Medium Changer 0 = Not supported
RelAdr: Relative Address 0 = Not supported
Linked: Linked commands 0 = Not supported
CmdQue: Command Queuing 0 = Not supported
Vendor Identification STK = StorageTek, Sun Microsystems (ASCII)
Product Identification:
Device type in ASCII
T10000A = Drive is a T10000A
T10000B = Drive is a T10000B
T10000C = Drive is a T10000C
T10000D = Drive is a T10000D
To Next Page
Loading...
Need help?
General