38
The digital display will quickly
blink 3 times to confirm the setting.
Press the MODE key
3 times or keep it pressed
for 2 sec. or more.
Turn the Jog switch
once toward the
‘’ direction.
6-3. Digital Display Inversion Function
This function can be used to invert the display orientation, according to the direction of amplifier installation.
1 Press the [MODE key] 5 times to select ‘PRO mode’.
2 Turn the [Jog switch] twice toward the ‘’ direction,
to select ‘PRO2 mode’.
3
Press the [Jog switch] to enter the ‘digital display setting’ state.
4
Turn the [Jog switch] once toward the ‘’ direction,
to enter the ‘digital display inversion setting’ state.
5 If the [Jog switch] is pressed, the current ‘display orientation’
will be displayed.
* The factory setting is ‘Turn OFF’.
6 If the [Jog switch] is turned, the digital display will blink.
Select the desired ‘display orientation’.
7 If the [Jog switch] is pressed, the digital display will quickly
blink 3 times, confirming the ‘display orientation’ setting.
8 Press the [MODE key] 3 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
To return the display to the original state, select the
‘Turn OFF’ setting.
Press the MODE
key 5 times.
Turn the Jog switch
twice toward the
‘
’ direction.
Press the
Jog switch.
Turn OFF
In case of
Turn ON
Turn ON
Press the
Jog switch.
Press the
Jog switch.
Turn the Jog switch to select
the desired display orientation.
To Next Page
Loading...
Need help?
General