Pfaff 1471 E1 User Manual

Adjustment
13.07.14 Scissor driving rod
Requirement
1. In its starting position the scissor must be flush with the needle plate contour.
2. At the TDC of the driving rod 2 there must be a safety clearance of at least 0.3 mm
between pin 4 and the top end of the cam guide.
● Bring the needle bar to BDC and activate the engaging lever by hand.
● Bring driving rod 2 to its top point of reversal by turning the handwheel.
● Carry out the alteration on the driving rod 2 ( screw 1 ), the eccentric sleeve 3 ( screw 4 )
and/or the eccentric pin 5 ( screw 6 ) in accordance with the requirement.
● Check the requirement from chapter 13.07.13 Eccentric sleeve.
● Bring the thread trimmer to its starting position using the handwheel.
If using the 1474E1 model, carry out the same adjustment on the second post.
5
2
6
3
4
Fig. 13 - 46
5
0.3 mm
1
13 - 51

Pfaff 1471 E1 Specifications

General

Brand	Pfaff
Model	1471 E1
Category	Sewing Machine
Language	English