Pfaff 360 User Manual

General Chedtup
Before the machine is delivered to the customer it must be given a thorough
checkup to ascertain that it
will function properly. Unfortunately, all kinds of
sewing trouble may be caused in transit.
Winding the Bobbin
To make the machine ready for sewing, wind No. 60 thread on the bobbin, at ·
the same time checking the correct working of the bobbin winder. Check to
see, in particular, that the bobbin is wound evenly and that the bobbin winder
stops automatically when the bobbin is full (see page 16).
Inserting the Bobbin Case
Insert o full bobbin into the bobbin case and check the tension on the bobbin
thread (see page 15).
Hoving ascertained that the tension is correct, check to see that the needle is
above the needle plate before you insert the bobbin case in the machine.
With
the thumb and forefinger of ·your left hand, lift bobbin case latch k and
turn the bobbin case until the slot marked with on arrow in Fig . 34 points up.
Then
place it on center stud s in the bobbin case base.
Release latch k and press aga inst the bobbin case until you hear it snap into
place. An improperly inserted bobbin case is op t to cause needle breakage.
In replacing the bobbin case make sure that the loose end of the bobbin
thread will not get jammed in the hook raceway.
Fig. 33 Engaging and disengaging the sewing
mechanism
Fig. 34 Inserting the bobbin case
17

Pfaff 360 Specifications

General

Brand	Pfaff
Model	360
Category	Sewing Machine
Language	English