To Next Page

To Previous Page

2.12

MAINTENANCE

9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual

VEHICLE INSPECTION

Shift Link Rod Inspection

NOTE: Shift rod is preset at time of manufacturer.

1. Lubricate pivot points with a light aerosol lubricant or

grease if desired.

Throttle Inspection

Check for smooth throttle opening and closing in all

handlebar positions. Throttle lever operation should be

smooth and lever must return freely without binding.

1. Place the gear selector in Park.

2. Set parking brake.

3. Start the engine and let it idle.

4. Turn handlebars from full right to full left. If idle speed

increases at any point in the turning range, inspect

throttle cable routing and condition. Adjust cable

tension as needed until lock-to-lock turning can be

accomplished with no rise in engine rpm.

5. Replace the throttle cable if worn, kinked, or

damaged.

To remove the ETC cover:

1. Use a medium flat blade screwdriver and insert blade

into the pocket of the cover starting on the #1

position.

2. Twist screwdriver slightly while lifting on the cover to

release snap.

3. Repeat procedure at the other five locations as

shown.

NOTE: Do not attempt to remove cover until all latch

points are released.

Shift Mount

Shifter

Shift Link Rod

ETC Cover

Removal Sequence

III. 1

Polaris A12MH46AX User Manual

Questions and Answers: