5
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
5.11
DRIVE BELT
BELT REMOVAL
NOTE
Inspect the entire clutch outlet duct when replacing a
drive belt. Remove any debris found in the outlet duct.
1. Remove the eight screws that retain the outer clutch
cover.
2. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
3. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
4. BASE and INTL Models ONLY: Loosen the driven
clutch retaining bolt to help spread the clutch
sheaves.
5. LE Models: Insert clutch spreader tool (2877408)
into the driven clutch as shown.
NOTE
Make sure the tool is square with the moveable sheave
surface of the driven clutch.
6. Rotate tool towards the clutch to open the sheaves.
7. ALL Models: Walk the belt out of the driven clutch
and drive clutch. Remove the belt from the vehicle.
BELT INSPECTION
1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
PVT SYSTEM
To Next Page
Loading...
Need help?
General
