7.12
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
9. Remove the drive shaft from the front bearing carrier.
10. With a short, sharp jerk, remove drive shaft from the
front gearcase.
FRONT DRIVE SHAFT INSTALLATION
1. Install new spring ring on drive shaft. Apply an anti-
seize compound to splines.
2. Align splines of drive shaft with front gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary
3. Install drive shaft into the front bearing carrier.
4. Install the upper ball joint end into the front bearing
carrier.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
