11
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
11.17
2. Place the ohmmeter leads onto the switch terminals.
The reading should be infinite (OL).
3. Apply the parking brake. Continuity should now exist
between the switch terminals. If no continuity exists
when the parking brake is applied, try to clean the
switch terminals and re-test. Replace switch if
necessary.
Park Brake Indicator
This warning is used to notify the operator that the
park brake lever is engaged.
When the parking brake is fully engaged, “BRAKE”
appears in the rider information display. Engine
speed is limited to 1500 RPM in all gears, except
neutral. If throttle is applied, this limiting feature
prevents operation, which protects the park brake
pads from excessive wear.
SPEED SENSOR LOCATION
The speed sensor is located on the RH side of the
transmission and can be accessed through the rear RH
wheel well area.
ELECTRICAL
To Next Page
Loading...
Need help?
General
