11.32
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
LIGHTING SYSTEM
HEADLIGHT ADJUSTMENT
The headlight beam is adjustable.
1. Place the vehicle on a level surface with the
headlight approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
3. With the machine in Park, start the engine and turn
the headlight switch to on.
4. The most intense part of the headlight beam should
be aimed 8 in. (20 cm) below the mark placed on the
wall in Step 2.
NOTE
Rider weight must be included in the seat while
performing this procedure.
5. Adjust the beam to the desired position by loosening
the adjustment screw (A) and moving the lamp to the
appropriate height.
6. Adjust the beam to desired position. Repeat the
procedure to adjust the other headlight.
WARNING
Due to the nature of light utility vehicles and where they
are operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.
ELECTRICAL
To Next Page
Loading...
Need help?
General
