To Next Page

To Previous Page

7.8

9926813 R04 - 2013-2016 RZR 570 Service Manual

REAR BEARING REPLACEMENT

Bearing Removal

1. Remove outer snap ring.

2. From the back side of the bearing carrier, tap on the

outer bearing race with a drift punch in the reliefs as

shown.

3. Drive bearing out evenly by tapping on outer race

only. Once bearing is at bottom of casting, support

casting on outer edges so bearing can be removed.

4. Inspect the bearing carrier housing for scratches,

wear or damage. Replace rear bearing carrier if

damaged.

Bearing Installation

5. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

6. Support the bottom of the bearing carrier housing.

CAUTION

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

7. Apply Loctite

603 retaining compound to the outer

circumference of the new bearing race and carefully

press the new bearing into the bearing carrier

housing.

NOTE

Use care to not allow any of the Loctite

compound to

get in the bearing.

8. Wipe the housing clean of any excess compound

and install the snap ring.

FINAL DRIVE

Polaris RZR 570 2013 Service Manual

Questions and Answers: