6.6
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
TRANSMISSION SERVICE
TRANSMISSION REMOVAL
CAUTION
Correct Drive Clutch Puller P/N PA-48595
1. If internal transmission repair is required, drain the
transmission lubricant (see Chapter 2 –
Transmission Lubrication, page 2.25).
2. Remove the seats and engine service panel (see
Chapter 10 – BODY COMPONENT REMOVAL,
page ).
3. Disconnect the (-) negative battery cable from the
battery.
4. Raise and support the vehicle.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this
procedure. Always wear eye protection.
5. Remove rear wheels from the vehicle.
6. From the right-hand front wheel well, locate the
propshaft roll pin. Use the Roll Pin Removal Tool to
remove the roll pin from the front gearcase.
Roll Pin Removal Tool:
2872608
7. Remove the gear selector cap and remove the
retaining screw and handle.
8. Remove the Torx screws retaining the center console
to access the propshaft.
9. Slide prop shaft back far enough to remove it from
the front gearcase input shaft splines.
10. Pull sharply forward to remove the propshaft from
transmission shaft.
11. Remove the rear bumper and cargo box as an
assembly (see Chapter 10 – BODY COMPONENT
REMOVAL, page ).
TRANSMISSION
To Next Page
Loading...
Need help?
General
