10
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
10.17
CARGO BOX ASSEMBLY REMOVAL
1. Remove the seats and the engine service panel.
2. Disconnect the harness connectors at the tail lights.
3. Disengage the tail light harness from the routing
features molded into the rear box on both sides.
4. Remove the cargo box access panel.
5. Remove the ten T-27 Torx screws retaining rear
bumper to the rear bumper support and storage box
(See Chapter 10 – Rear Bumper Removal, page
10.15).
6. Remove the six T-27 Torx screws (A) from the middle
of the cargo box.
7. Remove the four T-27 Torx Screws (B) from the front
of the cargo box.
8. Remove the six T-27 Torx Screws (C) from both
sides of the cargo box / rocker panels.
9. Remove the two push pins (D) from both sides of the
cargo box / rocker panels.
10. Remove intake grill and foam filters from the LH side
of the rear storage box.
11. Remove the seven T-25 Torx screws (E) securing
intake baffle to the rear storage box.
NOTE
Do not remove the baffle box along with the rear
storage box. The baffle box will remain with the vehicle
when the storage box is removed to prevent damage to
the crankcase vent tube.
12. With the aid of an assistant, carefully lift and guide
the cargo box assembly up and off of the vehicle
frame. Make note of wire and hose routings for
reassembly.
BODY / FRAME
To Next Page
Loading...
Need help?
General
