2.12
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
4. Place a drain pan beneath engine crankcase and
remove the drain plug
w
.
CAUTION
Oil may be hot. Do not allow hot oil to come into contact
with skin, as serious burns may result.
5. Allow oil to drain completely.
6. Replace sealing washer on drain plug.
NOTE
The sealing surface on the drain plug should be clean
and free of burrs, nicks or scratches.
7. Reinstall drain plug and torque to specification.
TORQUE
Crankcase Drain Plug:
12 ft-lbs (16 Nm)
8. Place a drain pan under vehicle below the oil filter
e
.
9. Place shop towels beneath oil filter. Using Oil Filter
Wrench (PU-50105) and a 3/8” extension, turn the oil
filter counter-clockwise to remove it.
Oil Filter Wrench:
PU-50105: 2.5″ (64 mm)
10. Using a clean dry cloth, clean filter sealing surface
on the crankcase.
11. Lubricate O-ring on new filter with a film of fresh
engine oil. Check to make sure the O-ring is in good
condition.
12. Install new filter and tighten to specification.
TORQUE
Oil Filter:Turn by hand until filter gasket contacts
sealing surface, then turn an additional 3/4 turn.
13. Remove the engine oil dipstick
q
.
14. Add oil as necessary to bring the oil level to the
upper mark on the dipstick. Do not over fill the
engine, the maximum oil capacity is 2 qts(1.9 l).
NOTE
The dipstick must be screwed completely in to ensure
accurate measurement.
15. Reinstall the upper fill cap (if removed) and tighten
the dipstick.
16. Verify the transmission is still positioned in PARK (P).
17. Start the engine and let it idle for two minutes.
18. Stop the engine and inspect for leaks.
MAINTENANCE
To Next Page
Loading...
Need help?
General
