2.26
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
WHEEL INSTALLATION
1. Verify the transmission is still in PARK.
2. Place the wheel in the correct position on the wheel
hub. Be sure the valve stem is toward the outside and
rotation arrows on the tire point toward forward
rotation.
3. Attach the wheel nuts
q
and finger tighten them.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts to the proper torque
specification.
TORQUE
Wheel Lug Nuts:
148 ft-lbs (200 Nm)
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear.
TIRE INSPECTION
• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original equipment
size and type.
• The use of non-standard size or type tires may affect
vehicle handling.
MEASUREMENT
Tire Lug Service Limit:
Replace if 1/8″ (3 mm) or less.
WARNING
Operating with worn tires will increase the possibility of
the vehicle skidding easily with possible loss of control.
Worn tires can cause an accident. Always replace tires
when the usable tread depth has worn out.
TIRE PRESSURE
Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle’s
tool kit.
TIRE PRESSURE SPECIFICATION (COLD)
MODEL FRONT
REAR
RZR PRO R
15 psi (103
kPa)
15 psi (103
kPa)
RZR PRO R 4
18 psi (124
kPa)
18 psi (124
kPa)
MAINTENANCE
To Next Page
Loading...
Need help?
General
