Polaris RZR PRO R User Manual

9
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
9.7
INSTALLATION
1. Reverse removal procedure for installation.
TORQUE
Tilt Bracket Mounting Fasteners:
33 ft-lbs (45 Nm)
Front Coil Assembly Fasteners:
27 in-lbs (3 Nm
Coil Assembly Side Fastener:
27 in-lbs (3 Nm
Steering Wheel Nut:
66 ft-lbs (90 Nm)
Steering Shaft Bearing Fasteners:
22 ft-lbs (30 Nm)
Steering Shaft Pinch Bolt:
22 ft-lbs (30 Nm)
EPS UNIT / STEERING RACK
REPLACEMENT
REMOVAL
1. Remove upper and lower steering shaft. Refer to
lower steering shaft removal outlined in this chapter.
2. Remove four front fascia fasteners
q
and remove
front fascia.
3. Remove four fasteners
i
and remove the front
bumper.
4. Both sides of vehicle: Remove ball joint pinch bolt
w
,
washer, and nut from the upper control arms.
5. Driver’s side only: Remove two control arm mounting
fasteners
e
.
IMPORTANT
The access panel must be removed from the driver’s
side footwell to remove rear upper control arm fastener.
STEERING / SUSPENSION

Polaris RZR PRO R Specifications

General

Brand	Polaris
Model	RZR PRO R
Category	Offroad Vehicle
Language	English