To Next Page

To Previous Page

9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual

6.5

BELT INSTALLATION

1. With the clutch spreader tool installed, loop the belt

over the drive clutch and over part of the driven

clutch. Be sure to install belt in the direction

previously marked.

2. Rotate the driven clutch and walk the belt into the

clutch.

3. Remove the clutch spreader tool from the driven

clutch.

4. Rotate / spin the driven clutch and belt approximately

5-7 times to properly seat the belt in the driven clutch.

5. Install outer clutch cover. Install five fasteners

and

engage 1/4 turn latches to secure the cover. Torque

fasteners to specification.

TORQUE

Outer PVT Cover Fasteners:

60 in-lbs (7 Nm)

6. Install clutch intake hose. Tighten hose clamp

Torque hose clamp to specification.

TORQUE

PVT Intake Hose Clamp:

35 in-lbs (3 Nm)

7. Install upper and lower rear close-off panels.

8. Install seats. On 4-seat models, install the rear seats.

PVT SYSTEM

Polaris RZR PRO R User Manual

Questions and Answers: