To Next Page

To Previous Page

9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual

12.13

SWITCHES / CONTROLS

HEADLIGHT SWITCH

1. Disconnect the headlamp switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 3 sets of outputs (OFF / LOW /

HIGH). If any of the tests fail, replace headlight switch

assembly.

3. Move the switch to HI. There should be continuity

between switch pins 3 and 7; 6 and 4.

4. Move the switch to LOW. There should be continuity

between switch pins 6 and 4.

5. Move the switch to OFF. There should be no

continuity between switch pins.

POSITION FUNCTION TERMINALS

Up Hi Beam 3 and 7 closed,

6 and 4 closed

Neutral Low Beam 3 and 7 open, 6

and 4 closed

Down

Off

3 and 7 open, 6

and 4 open

IGNITION / KEY SWITCH

1. Disconnect the key switch harness by depressing the

connector lock and pulling on the connector. Do not

pull on the wiring.

2. Test between the 4 sets of outputs (OFF / ACCY / ON

/ START). If any of the tests fail, replace ignition

switch assembly.

• In the OFF position, there should be no continuity

between any of the pins.

• Turn the key to ACCY position. There should be

contunity between switch pins A and B.

• Turn the key to ON position. There should be

continuity between switch pins A, B and C.

• Turn the key to START position. There should be

continuity between A, B, and C; D and E.

ELECTRICAL

Polaris RZR PRO R User Manual

Questions and Answers: