EasyManuals Logo

Polaris RZR PRO R User Manual

Polaris RZR PRO R
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #178 background image
3.64
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
4. Remove four fasteners, breather assembly, and
gasket from the engine block.
5. Remove and discard the piston jet fasteners.
6. Remove the piston jet.
ENGINE BLOCK CLEANING AND
INSPECTION
1. Clean the sealing material from the gasket mating
surfaces
q
with a suitable tool.
2. Clean the engine block and lower crankcase in a
cleaning tank with solvent appropriate for aluminum.
3. Flush the engine block with clean water or steam.
4. Clean the oil passages.
5. Clean the blind holes.
6. Spray the cylinder bores and the machined surfaces
with engine oil.
7. Inspect the threaded holes. Clean the threaded holes
with a rifle brush. If necessary, drill out the holes and
install thread inserts.
NOTICE
Do not attempt to machine the lower crankcase to
engine block surfaces.
8. Use a straight edge and a feeler gauge to check the
deck surface for flatness. Carefully machine minor
irregularities. Replace the block if more than 0.010 in
(0.254 mm) must be removed.
9. Inspect the oil pan rail for nicks. Inspect the front
cover attaching area for nicks. Use a flat mill file to
remove any nicks.
10.Clean the sealing material from the gasket mating
surfaces on the lower crankcase engine block side
with a suitable tool.
11. Clean the sealing material from the gasket mating
surfaces on the lower crankcase oil pan side with a
suitable tool.
ENGINE / COOLING SYSTEM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris RZR PRO R and is the answer not in the manual?

Polaris RZR PRO R Specifications

General IconGeneral
BrandPolaris
ModelRZR PRO R
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals