To Next Page

To Previous Page

9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual

10.23

TROUBLESHOOTING

BRAKE PEDAL SWITCH INSPECTION

The Brake Pedal Switch is mounted near the Brake

Pedal Assembly. When the brake pedal is depressed this

switch will turn from active to inactive. This can be

monitored using Digital Wrench ®. If the status does not

switch when depressed, proceed with further testing.

1. Disconnect electrical connector from sensor.

2. Inspect sensor and connector for moisture or

corrosion. If moisture or corrosion is found, clean first

and re check.

3. With connector disconnected, check resistance

across pins on the sensor. When switch is inactive

(brake pedal not depressed) resistance should be

less than 0.5 ohms. With switch active (brake pedal

depressed) resistance should show an open (OL).

4. If the sensor test fails, resistance is not within

specification; the sensor should be replaced.

5. If the sensor test passes, resistance is within

specification, inspect the circuit for correct operation.

If there is a concern found with the circuit repair and

recheck operation.

6. If the concern is still present, it is possible that there

may be a concern with the ECU.

BRAKE PEDAL

BRAKE SWITCH

Brake pedal depressed Active

Brake pedal released Inactive

BRAKE SYSTEM

Polaris RZR PRO R User Manual

Questions and Answers: