To Next Page

To Previous Page

2.30

9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual

WHEEL TOE ADJUSTMENT

If toe alignment is incorrect, repeat steps 3-5 of “Wheel

Toe Alignment Inspection”, but instead measure the

distance between each wheel and the vehicle center.

This will tell you which tie rod needs adjusting.

NOTICE

Be sure steering wheel is straight ahead before

determining which tie rod needs adjustment.

CAUTION

During tie rod adjustment, it is very important that the

following precautions be taken when tightening tie rod

end jam nuts.

If the rod end is positioned incorrectly it will not pivot,

and may break.

To adjust toe alignment:

• Hold tie rod end to keep it from rotating.

• Loosen jam nuts at both end of the tie rod.

• Shorten or lengthen the tie rod until alignment is as

required to achieve the proper toe setting as specified.

MEASUREMENT

Wheel Toe:

1/4” (6.35 mm) toe-in – 1/4” (6.35 mm) toe-out

• After alignment is complete, torque jam nuts to

specification.

TORQUE

Tie Rod Jam Nut:

89 ft-lbs (120 Nm)

CAUTION

When tightening the tie rod end jam nuts, the rod ends

must be held parallel to prevent rod end damage and

premature wear. Damage may not be immediately

apparent if done incorrectly.

• Vehicles equipped with Dynamix suspension having a

steering shaft, EPS unit, steering rack, or tie rod

removed/adjusted/disconnected MUST have Steering

Angle Sensor Centering procedure performed once

everything is reinstalled. Refer to Steering Angle

Sensor Centering (Dynamix) page .

MAINTENANCE

Polaris RZR PRO R User Manual

Questions and Answers: