Polaris RZR PRO R User Manual

8
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
8.13
10.Install and tighten the large clamp
e
using the
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
11. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize in
the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
12.Install and tighten the small clamp
r
on the boot
using the appropriate clamp tool.
FINAL DRIVE

Polaris RZR PRO R Specifications

General

Brand	Polaris
Model	RZR PRO R
Category	Offroad Vehicle
Language	English