Commands Menu 5-37
22 June 2004
Position to Elem Dialog
Path: Main Menu Commands Menu Move
Submenu Position to Elem Dialog
Use the Position to Elem to move the Accessor in front of
a specific element. See Figure 5-43.
Figure 5-43 Position to Elem Dialog
Parameter Value
Coord The first field indicates the
type of cell (I for I/E Station, D
for Drive, S for Storage cell).
The second field displays
module numbers that can be
modified if EMs are present (1–
4).
The third field indicates the
storage cell section (1–4), drive
bay (1–2), or IE station number.
The fourth field indicates the
column of the section (A–E),
drive port (A–B), or IE station
column.
The fifth field indicates the row
of the column.
(01–12 for ½-inch and SDLT/
DLT coordinates)
(01–14 for LTO coordinates)
(01–18 for AIT coordinates)
Element Displays the element index
that corresponds to the
coordinate parameter.
Accept Y to accept changes
N to reject changes
Enter TARGET
Coord: S< 01 2 A 01
OR Element : 00000
Accept: N
To Next Page
Loading...
Need help?
General