5-134 Menus and Commands
6-00054-02 Rev A
Move Dialog
Path: Main Menu Service Menu Diags
Submenu Accessor Submenu Move Dialog
Use the Move Dialog to move the Accessor in a figure eight
pattern without accessing cartridges. See Figure 5-183.
Figure 5-183 Move Dialog
Parameter Value
Cycles to Run Indicates the desired cycle
count (001–999).
Accept Y to accept changes
N to reject changes
If Y is selected for the Accept parameter value, the
Response Dialog appears. Refer to Figure 5-184.
Otherwise, the changed parameters continue to display
but no action is taken.
Figure 5-184 Response Dialog
Parameter Value
Cycle Displays the number of
completed test cycles of
requested cycles.
Status Displays the current cycle
(Running, Completed, Error,
Canceled).
Cancel Y to cancel the test
N to continue running the test
If Y is selected for the Cancel parameter value, the test is
cancelled. Otherwise, the test continues.
The accessor test
does corner moves.
Cycles to run: 009<
Accept: N
DIAGS ACCESSOR TEST
Cycle : 006 of 009
Status: Running
Cancel: N<
Note
If the operation
stops, the Cancel
parameter no
longer displays.
To Next Page
Loading...
Need help?
General