Status Menu 5-19
22 June 2004
Reservations Dialog
Path: Main Menu Status Menu Library
Submenu SCSI Submenu Reservations Dialog
Use the Reservations Dialog to view a specific element,
or the entire library. See Figure 5-15.
This reservation remains in effect until:
• The initiator that made the reservation sends another
command with the same Reservation Identification
number (this supersedes any previous reservation).
• The initiator that made the reservation sends a RELEASE
command.
A reset or a power-on of the library is performed.
Figure 5-15 Reservation Dialog
Parameter Value
Bus Displays the SCSI Bus ID
number (0–1)
Host ID Displays the Host ID number
(0–7)
Reservation ID Displays the host’s reservation
identifier (0x00–0xFF, Any)
Found The value of the Found
parameter in the Reservation
Dialog is supplied by the
library firmware and cannot be
changed.
Accept Y to accept changes
N to reject changes
If Y is selected for the Accept parameter value, the
Response Dialog appears. See Figure 5-16 on page 5-20.
Otherwise, the changed parameters continue to display
but no action is taken.
Bus : 0 < Host ID : 0
Reservation ID: Any
Found : 0000
Accept: N
To Next Page
Loading...
Need help?
General