5-78 Menus and Commands
6-00054-02 Rev A
Trace Dialog
Path: Main Menu Setup Menu Library
Submenu Trace Dialog
Use the Trace Dialog to define and enable the serial
service port. See Figure 5-105.
Figure 5-105 Trace Dialog
Parameter Value
USE SERIAL indicates information
is returned via the serial port.
NONE/RMU is the default to
allow the port to be used for
RMU communication.
VCONSOL is used for
development only.
Accept Y to accept changes
N to reject changes
If Y is selected for the Accept parameter value, the screen
updates to reflect the changes. Otherwise, the changed
parameters continue to display but no action is taken.
Trace output
USE: NONE/RMU<
Accept: N
Note
If the RMU is not
installed, this
option must be
set to SERIAL in
order to prevent a
SAC from being
posted.
To Next Page
Loading...
Need help?
General