UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 100 / 247
Parameter
7.16. AT+CR Service Reporting Control
AT+CR controls the module whether or not to transmit an intermediate result code +CR: <serv> to the TE
when a call is being set up.
If it is enabled, an intermediate result code is transmitted at the point during connect negotiation at which
the TA has determined which speed and quality of service will be used, before any error control or data
compression reports are transmitted, and before any final result code (e.g. CONNECT) is transmitted.
<idx> Integer type; call identification number as described in 3GPP TS 22.030 sub clause 4.5.5.1;
this number can be used in AT+CHLD command operations
<dir> 0 Mobile originated (MO) call
1 Mobile terminated (MT) call
<stat> State of the call
0 Active
1 Held
2 Dialing (MO call)
3 Alerting (MO call)
4 Incoming (MT call)
5 Waiting (MT call)
<mode> Bearer/tele service
0 Voice
1 Data
2 FAX
<mpty> 0 Call is not one of multiparty (conference) call parties
1 Call is one of multiparty (conference) call parties
<number> Phone number in string type in format specified by <type>
<type> Type of address of octet in integer format(Refer to 3GPP TS 24.008 , sub clause 10.5.4.7
for details). Usually, it has three kinds of values:
129 Unknown type
145 International type(contains the character "+")
161 National type
<alpha> Alphanumeric representation of <number> corresponding to the entry found in phonebook
AT+CR Service Reporting Control
Response
+CR: (list of supported <mode>s)
To Next Page
Loading...
Need help?
General
