Quectel UG Series User Manual

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 43 / 247
The configuration will be saved to NV automatically.
4.3.4. AT+QCFG="urc/ri/smsincoming" Ring Line Behavior of Incoming SMS
AT+QCFG="urc/ri/smsincoming" specifies the behavior of ring line when related incoming message URCs
are presented. Related incoming message URCs list: +CMTI,+CMT,+CDS,+CBM.
Parameter
Value ranges from 1 to 5 and default is 1. The interval time between two
pulses is equal to <pulse_duration>.
AT+QCFG="urc/ri/smsincoming" Ring Line Behavior of Incoming SMS
Write Command
AT+QCFG="urc/ri/smsincoming"[,<typ
eri>[,<pulse_duration>[,<pulse_count
>]]]
Response
If configuration parameters are omitted
(+QCFG="urc/ri/smsincoming"), return current
configuration:
+QCFG:
"urc/ri/smsincoming",<typeri>,<pulse_duration>,<pulse
_count>
OK
If configuration parameters are entered:
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
Maximum Response Time
300ms
<typeri> The behavior of the ring line when URC are presented
"off" No change. Ring line keeps inactive
"pulse" Pulse. Pulse width determined by <pulse_duration>
"always" Change to active. You should restore to inactive by +QRIR
<pulse_duration> Set the width of pulse. Value ranges from 1 to 2000ms and the default is 120ms.
This parameter is only valid when <typeri> is “pulse”.
<pulse_count> The count of pulse. This parameter is only meaningful when <typeri> is “pulse”.
Value ranges from 1 to 5 and default is 1. The interval time between two pulses
NOTE
Quectel
Confidential

Quectel UG Series Specifications

General

Brand	Quectel
Model	UG Series
Category	Control Unit
Language	English