UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 21 / 247
does not change the current baud rate of UART.
Parameter
<value> 0 Reset to profile number 0
2.15. ATQ Set Result Code Presentation Mode
ATQ controls whether the result code is transmitted to the TE. Other information text transmitted as
response is not affected.
Parameter
ATZ Set all Current Parameters to User Defined Profile
Execution Command
ATZ[<value>]
Response
TA sets all current parameters to the user defined profile. See
Table 9: AT Command Settings Storable with ATZ.
OK
ATQ Set Result Code Presentation Mode
Response
This parameter setting determines whether or not the TA
transmits any result code to the TE. Information text
transmitted in response is not affected by this setting.
If <n>=0:
OK
If <n>=1:
(none)
<n> 0 TA transmits result code
1 Result codes are suppressed and not transmitted
To Next Page
Loading...
Need help?
General
