UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 54 / 247
Parameter
UG95 module does not support this function.
4.3.14. AT+QCFG="remoteip" Enable/Disable Remote IP Function
AT+QCFG="remoteip" is used to set the function whether or not “remoteip” negotiation will be injected
during the PPP dialing period. This parameter will not be saved and it will be effective immediately after
setting.
<enable> 0 Character escape function of SMS text is disabled
1 Character escape function of SMS text is enabled
When AT+CSCS=“GSM” or AT+CSCS=“IRA”, in SMS text outputting:
0x5C (show in hex, character Ö in GSM, character \ in ASCII) will be
escaped into 0x5C3543 (“\5C”).
0x0D (show in hex, character <CR> in GSM and IRA) will be escaped into
0x5C3044 (“\0D”).
0x0A (show in hex, character <LF> in GSM and IRA) will be escaped into
0x5C3041 (“\0A”).
0x22 (show in hex, character “ in GSM and IRA) will be escaped into
0x5C3232 (“\22”).
0x00 (show in hex, character @ in GSM) will be escaped into 0x5C3030
(“\00”).
AT+QCFG="remoteip" Enable/Disable Remote IP Function
Write Command
AT+QCFG="remoteip"[,<remot
eIPsel>]
Response
If <remoteipsel> is absence which means read.
+QCFG: "remoteip",<remoteIPsel>
OK
If none is absence which means setting parameters.
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
To Next Page
Loading...
Need help?
General
